Skip to content
English
  • There are no suggestions because the search field is empty.

UltraBreeze: Testing the Fan Blade

A damaged or loose fan blade is the usual cause of a noisy UltraBreeze. Check it from inside the attic.

Tools

  • 1/8 in. Allen key

Steps

  1. Unplug the thermal: find the plug hanging from the base of the fan and pull the two black connectors apart. This cuts the solar power to the fan. Pull on the connectors, not the wires.
  2. Look the blade over for bends, cracks or other damage. A damaged blade needs replacing; contact us and we'll send one.
  3. Check that the blade's hub sits flush with the end of the motor shaft. If it does, and the blade isn't damaged, the blade is fine.
  4. If it isn't flush, loosen the 1/8 in. Allen screw on the hub. Line the screw up with the flat side of the motor shaft, slide the hub flush with the end of the shaft, and tighten. Don't bend the blade.
  5. Make sure nothing is in the blade's way, then plug the thermal back in. Push the connectors together until no metal shows between them.
  6. Watch it run. A good blade turns smoothly, with little noise and no shaking. Loud noise or a shaking housing? Contact us.

To swap the blade, see UltraBreeze: Replacing the Fan Blade.

Need help? Contact UltraBreeze technical support at support@atticbreeze.com or (254) 865-9999, Monday through Friday, 8 AM to 5 PM Central.