UltraBreeze: Replacing the Solar Panel
Replace the solar panel on your UltraBreeze. You'll work in the attic and on the roof. Test the panel first (UltraBreeze: Testing the Solar Panel).
Tools
- 7/16 in. deep-well socket and ratchet
- Phillips screwdriver
- Flat screwdriver and multimeter (to check the junction box)
In the attic
- Unplug the thermal: find the plug hanging from the base of the fan and pull the two black connectors apart. This cuts the solar power to the fan. Pull on the connectors, not the wires.
On the roof
- Loosen the six 7/16 in. nuts on the solar panel bracket so the panel can move.
- Raise the panel and unplug its connector by pulling the two ends apart. Pull on the connectors, not the wires.
- Before replacing it, check the junction box on the back of the panel. Gently press up the four tabs with a flat screwdriver. The black wire belongs at the top right and the white wire at the bottom left. If they're swapped, move them, tighten the screws and test the panel again.
- Plug the new panel's connector into the fan's connector until no metal shows.
- Set the panel in the same position as the old one. In windstorm areas (Florida HVHZ, Texas TDI), the panel stays flat and secured.
- Tighten the six 7/16 in. nuts. Don't over-tighten.
Back in the attic
- Make sure nothing is in the blade's way, then plug the thermal back in. Push the connectors together until no metal shows between them.
Need help? Contact UltraBreeze technical support at support@atticbreeze.com or (254) 865-9999, Monday through Friday, 8 AM to 5 PM Central.